3D Systems CUBE Manual del usuario - Página 16

Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D 3D Systems CUBE. 3D Systems CUBE 20 páginas. Replacing the print tip
También para 3D Systems CUBE: Documentación (8 páginas), Lección (15 páginas)

Imprimir página

Select the

checkmark

NOTE: If Auto Gap is not successful, it is recommended that you perform Auto

Level and Auto Gap again. Select

NOTE: If Auto Gap is not successful the second time, select

MAINTENANCE. For more information, refer to the section titled

Maintenance. Once the Plate Maintenance procedure has been performed,

perform Auto Level and Auto Gap.

NOTE: If Auto Gap is still not successful, select

Refer to the section titled

the Manual Gap Adjustment procedure has been performed, note the ﬁnal

reading for future reference.

Gap Veriﬁcation

Print a test print from the System 1 menu. Once you have removed it from the print

pad, visually inspect the ﬁrst (bottom) layer of the print and verify the quality. Turn

the print upside down and inspect the printing grain. When the gap is optimal, the

bottom of the print should appear smooth and the lines should be very light and

fused together.

Correct Gap

The gap is correct when the bottom of the print appears smooth and the lines are

tightly fused together.

to continue.

AUTO LEVEL

Manual Gap Adjustment

to continue.

PLATE

Print Pad

MANUAL GAP

ADJUSTMENT.

for more information. Once