3D Systems CUBE Manual del usuario - Página 18

Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D 3D Systems CUBE. 3D Systems CUBE 20 páginas. Replacing the print tip
También para 3D Systems CUBE: Documentación (8 páginas), Lección (15 páginas)

Imprimir página

NOTE: The print pad must be clean and free from glue and print material.

NOTE: Ensure the print jet nozzles are clean and free from print material. This

can usually be accomplished by pulling out the print material with your

ﬁngers.

Caution: Ensure the print jet nozzles are at room temperature before

attempting to clean them.

Select

MANUAL GAP

Place the gap gauge on top of the print pad under the left print jet. Select the

checkmark

to continue.

NOTE: Ensure the left cartridge is installed before performing this procedure.

NOTE: The Gap Gauge is a thin polyester strip approximately 8.5" (216 mm)

long and 1.5" (38 mm) wide.

Gently slide the gap gauge back and forth between the print pad and the left print jet.

Using the arrows, raise or lower the print pad until you feel a slight resistance on the

gauge. Select the

Caution: Exercise caution to prevent the print jet from pressing into the print

pad. Once you feel a slight resistance in the Gap Gauge as it moves between

the print pad and the left print jet, the gap is correct.

ADJUSTMENT.

checkmark

when you feel the proper resistance.