3D Systems CUBE Manual del usuario - Página 17
Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D 3D Systems CUBE. 3D Systems CUBE 20 páginas. Replacing the print tip
También para 3D Systems CUBE: Documentación (8 páginas), Lección (15 páginas)
Imprimir página
Gap Is Too Large
If the lines are more prominent (see the illustration below) and not tightly fused, the
gap is too large. Auto Level and Auto Gap should be performed. When the gap is
too large, the first layer may begin to fray when removing the print from the print
pad.
Gap Is Too Narrow
When the gap is too narrow, the part may be very difficult to remove from the print
pad. In addition, the bottom layers may break off from the rest of the part while
removing it. The bottom of the first layer will appear very smooth and shiny with
almost no visible lines.
NOTE: If the bottom of the part appears shiny, make sure all glue has been
removed and then reinspect it.
Caution: Damage to the print pad can occur if the gap is too narrow.
Manual Gap Adjustment
If Auto Gap is unsuccessful, you may perform a manual gap adjustment to ensure
the first layer of the part prints properly.