ALUZ ZIBI A1 Series Manual - Página 11
Navegue en línea o descargue pdf Manual para Equipos de iluminación ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 13 páginas. Surface zuco pivot bios illuminated
También para ALUZ ZIBI A1 Series: Manual de instrucciones de instalación (12 páginas), Manual (11 páginas), Manual (11 páginas), Manual de instrucciones de instalación (11 páginas)
Imprimir página1
Determine number of reflectors needed. Reflectors are available in
1', 2', 3', or 4' increments. Specify total length of reflectors needed.
2
Position reflectors on luminaires, then install 3 set screws on each
reflector segment to secure in place. Do not over-tighten set screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
3
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
4
Mount luminaires at least 12" away from the wall.
Page 11 of 13
Reflector (A1-ZIBI-STN-RE1)
12"
Installation Instructions
9 / 11 / 2023 / Rev 4