ALUZ ZIBI A1 Series Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Pencahayaan ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 13 halaman. Surface zuco pivot bios illuminated
Juga untuk ALUZ ZIBI A1 Series: Panduan Petunjuk Instalasi (12 halaman), Manual (11 halaman), Manual (11 halaman), Panduan Petunjuk Instalasi (11 halaman)

1
Determine number of reflectors needed. Reflectors are available in
1', 2', 3', or 4' increments. Specify total length of reflectors needed.
2
Position reflectors on luminaires, then install 3 set screws on each
reflector segment to secure in place. Do not over-tighten set screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
3
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
4
Mount luminaires at least 12" away from the wall.
Page 11 of 13
Reflector (A1-ZIBI-STN-RE1)
12"
Installation Instructions
9 / 11 / 2023 / Rev 4