Dolby Laboratories CP750 Manual de instalación - Página 9
Navegue en línea o descargue pdf Manual de instalación para Hardware informático Dolby Laboratories CP750. Dolby Laboratories CP750 19 páginas. 7.1 audio for the dolby multichannel amplifier
Imprimir página
- 1. Introduction to Dolby Cp750 7.1 Audio for the Dolby Multichannel Amplifier
- 2. About the Cp750 (or Other Cinema Processor) Configuration for the
- 3. Connecting a Cp750 (or Other Sound Processor) to a Media Block
- 4. Configuring Advanced Connections
- 5. Cp750 Audio Output Cable Pinouts
- 6. To 25-Pin D-Connector Digital Audio Pinouts
Procedure
1. Connect the rear-panel Dante Primary port to the network switch.
2. Set the rear-panel DIP switches.
DIP switch setting
1 up (off)
2 up (off)
3 up (off)
4 up (off)
5 up (off)
6 down (on)
7 up (off)
8 up (off)
3. Slide the front-panel UNIT ID switch to 1.
4. Slide the front-panel QUICK CONFIG switch to OFF.
5. Slide the front-panel +48V MASTER switch to OFF.
6. Connect the power cord to the rear-panel AC input port, then press the front-panel power
button to turn the unit on.
You will connect the analog inputs and digital outputs later when you interconnect all of the
hardware components.
3.2 Interconnecting the hardware
To use the CP750 (or other cinema processor) with a Dolby Multichannel Amplifier, you need to
interconnect the required hardware.
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Function
Sets the device ID range to 1, 2, or 3.
Sets the device ID range to 1, 2, or 3.
Unit will retain its settings after a reboot.
Unit will use the primary Ethernet port.
Unit will start in DHCP mode (also supports local IP addressing).
Unit will start in DHCP mode (also supports local IP addressing).
Unit boots up in normal mode.
Unit boots up in normal mode.
Setting up the system
9