Dolby Laboratories CP750 설치 매뉴얼 - 페이지 9

{카테고리_이름} Dolby Laboratories CP750에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dolby Laboratories CP750 19 페이지. 7.1 audio for the dolby multichannel amplifier

페이지 인쇄

Procedure

1. Connect the rear-panel Dante Primary port to the network switch.

2. Set the rear-panel DIP switches.

DIP switch setting

1 up (off)

2 up (off)

3 up (off)

4 up (off)

5 up (off)

6 down (on)

7 up (off)

8 up (off)

3. Slide the front-panel UNIT ID switch to 1.

4. Slide the front-panel QUICK CONFIG switch to OFF.

5. Slide the front-panel +48V MASTER switch to OFF.

6. Connect the power cord to the rear-panel AC input port, then press the front-panel power

button to turn the unit on.

You will connect the analog inputs and digital outputs later when you interconnect all of the

hardware components.

3.2 Interconnecting the hardware

To use the CP750 (or other cinema processor) with a Dolby Multichannel Amplifier, you need to

interconnect the required hardware.

Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual

7 May 2018 Issue 1

Function

Sets the device ID range to 1, 2, or 3.

Unit will retain its settings after a reboot.

Unit will use the primary Ethernet port.

Unit will start in DHCP mode (also supports local IP addressing).

Unit boots up in normal mode.

Setting up the system