Dolby Laboratories CP750 설치 매뉴얼 - 페이지 16
{카테고리_이름} Dolby Laboratories CP750에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dolby Laboratories CP750 19 페이지. 7.1 audio for the dolby multichannel amplifier
페이지 인쇄
- 1. Introduction to Dolby Cp750 7.1 Audio for the Dolby Multichannel Amplifier
- 2. About the Cp750 (or Other Cinema Processor) Configuration for the
- 3. Connecting a Cp750 (or Other Sound Processor) to a Media Block
- 4. Configuring Advanced Connections
- 5. Cp750 Audio Output Cable Pinouts
- 6. To 25-Pin D-Connector Digital Audio Pinouts
3 = Center
4 = Low-Frequency Effects/subwoofer
5 = Left Surround
6 = Right Surround
7 = Left Rear Surround
8 = Right Rear Surround
Note: Depending on the number of speakers and power requirements, you may need to
configure additional channels. For example, if the stage channels are biamped, you can
assign input 1 to two outputs. If there is more than one Low-Frequency Effects unit, you
can assign input 4 to two or more outputs to drive all of the speakers.
9. Click Apply to save your routing assignments or Cancel to discard your changes.
10. Click Status in the navigation bar.
The Clock Lock indicator on the Status screen should now illuminate in blue, indicating that
it is on. The audio stream will now pass through to the speakers.
3.5 Configuring advanced connections
We recommend that you connect the Yamaha Tio1608-D to the Dolby Multichannel Amplifier
using only a direct connection between these devices on a Dolby Atmos Connect network. In
such a configuration, this prevents audio transmission problems between the two devices, as
bandwidth on a network switch is not used. Typically, there is no need to access the Yamaha
controls using Dante Controller or R-Remote software after the setup is complete. However, if
more than one Yamaha device is installed on the network, you need to follow specific
instructions to ensure that you transmit the desired audio.
About this task
If more than one Yamaha device is installed on the network, it may be best to attach the Dolby
Atmos Connect cable from the amplifier to a Command network switch. In this type of
configuration, more than one Yamaha unit appears in the Dolby Multichannel Amplifier
Network > Dolby Atmos Connect > Available Sessions screen. In such a case, you need to use
the Dante Controller or R-Remote software to ensure you transmit the desired audio from the
correct device.
Procedure
1. Select Network > Dolby Atmos Connect, and uncheck Manual mode to display the Dolby
Multichannel Amplifier Available Sessions screen.
The Input Stream 1 field displays one Yamaha Tio1608-D and the Input Stream3 field
displays another Yamaha Tio1608-D. Each device has a unique ID.
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Setting up the system
16