BlueSky Mast AL3 Series Hoja de referencia rápida - Página 2

Navegue en línea o descargue pdf Hoja de referencia rápida para Sistemas de elevación BlueSky Mast AL3 Series. BlueSky Mast AL3 Series 6 páginas.
También para BlueSky Mast AL3 Series: Hoja de referencia rápida (6 páginas)

Imprimir página
AL3 Lift Series - Deployment Quick Reference Sheet
21
Insert all 3 struts into the
receivers on the strut base plate
and secure the hitch pins.
26
1"
Leave 1 inch below the cam
lock and lock the cam lock.
31
Slide the guy handle towards
the mast approx. 7 feet and
drop on the ground.
36
Tighten the nut on the cam lock
a quarter turn until slipping no
longer occurs.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2013 Allendale LLC All Rights Reserved
22
Make sure the strut base plate
is centered under the tripod and
tighten all turn knobs.
27
Pin the
Red Primary Guy Ring
to the Mounting Pole below your
devices.
32
Continue this process until all 4
primary guy ropes have been
deployed 90 degrees apart.
37
Insert a center mast pole onto
the tapered cone on the lift base
plate.
23
Locate the
RED TIPPED strut
base plate stake
and hammer
it into the strut base plate.
28
Attach the red clip from the
primary guy rope to the round
hole on the guy ring.
33
Make sure the cam lock is
locked and lower the lift base
plate to the ground.
38
Raise the center mast pole until
it nest together into the bottom
of the mounting pole.
Read Manual Before Use
Refer to detailed instructions in the
AL3 Lift Series Manual at all times
24
Confirm the cable is taut and
the lift base plate is secure.
29
Unwind the guy rope and take
one normal step per meter of
height. 15 Meters = 15 Steps
34
WARNING: If at any point the
mast begins to slip while the
cam lock is locked - STOP
39
1"
Release the cam lock and raise
until 1 inch is showing below the
tripod. LOCK THE CAM LOCK
25
Release the cam lock on the
tripod and raise the mounting
pole by turning the winch.
30
Unwind all the remaining guy
rope and drive 2 stakes through
the dual stake plates.
35
Use the 7/16 wrench provided
with the system to make adjust-
ments.
40
Continue this process until you
have reached 1/2 the total mast
height.