BlueSky Mast AL3 Series Hoja de referencia rápida - Página 4

Navegue en línea o descargue pdf Hoja de referencia rápida para Sistemas de elevación BlueSky Mast AL3 Series. BlueSky Mast AL3 Series 6 páginas.
También para BlueSky Mast AL3 Series: Hoja de referencia rápida (6 páginas)

Imprimir página
AL3 Lift Series - Deployment Quick Reference Sheet
AL3 Lift Series - Lowering Quick Reference Sheet
1
Remove the stakes from the Lift
Base Plate by using the stake
puller.
6
Lower the base pole and lift
base plate to the ground &
remove the base pole.
11
Slowly lower the mast, lock the
cam lock and remove the center
mast pole.
15
Remove the 4 secondary guy
ropes and release the cam lock
on the secondary guy ring.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2013 Allendale LLC All Rights Reserved
2
Unlock the ALL guy ropes and
slide the guy handles toward
the guy stakes 12 inches.
7
Raise the lift base plate until it
inserts into the pole. Release
the cam lock.
12
Raise the lift base plate until it
inserts into the next pole.
16
Continue lowering the mast until
the primary guy ring is within
reach.
3
Release the cam lock.
8
WARNING: If at any point the
mast begins to slip while the
cam lock is locked - STOP
13
Adjust all 4 Primary Guy Ropes so the mast is straight and perpendicular.
You should only have to adjust the primary guy ropes for the first 3 - 4
center mast poles, unless you are experiencing high winds.
17
Remove the primary guy ropes
and stow all guying equipment.
Read Manual Before Use
Refer to detailed instructions in the
AL3 Lift Series Manual at all times
4
Raise the base pole up 12
inches.
9
Use the wrench provided with
the system to make adjust-
ments.
18
Remove the tripod leg struts
from the strut base plate and
secure the struts to the legs.
5
Lock the Cam Lock.
10
Tighten the nut on the cam lock
a quarter turn until slipping no
longer occurs.
14
Repeat this process until the
secondary guy ring is within
reach.
19
Remove the red tipped strut
base plate stake and stow the
strut base plate.