Follett 400 Series Manuel d'installation et d'entretien - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'entretien pour {nom_de_la_catégorie} Follett 400 Series. Follett 400 Series 20 pages. Icemaker and top kit for remcor/cornelius countertop ice and beverage dispensers

Imprimer la page

Operation

Weekly exterior evaporator unit care

The exterior may be cleaned with a stainless cleaner such as 3M Stainless Steel Cleaner & Polish or equivalent.

Recommended semi-annual icemaker/evaporator unit cleaning (every 6 months)

Solution A – Sanitizing solution: Prepare 2 gallons (9L)

Combine 1 oz (250ml) bleach with 2 gal (8L) hot water or use

200ppm of Ecolab Mikro-chlor Cleaner or equivalent 5.25% sodium

hypochlorite solution.

Solution B – Ice machine cleaner: Prepare one gallon (3.8L)

™

of Follett SafeCLEAN

Ice Machine Cleaner (one 7 oz packet) or

equivalent. Solution temperature must be at least 120° F

(48.9° C).

Warning: Most ice machine cleaners contain citric or phosphoric

acid that can cause skin irritation. Read caution label on product

and follow instructions carefully.

1. Remove icemaker panels required to gain access to water

reservoir components (Fig. 16) and electrical control box.

2. Locate icemaker electrical box and turn compressor switch off.

3. Dispense all ice from dispenser.

4. Shut off water to icemaker.

5. Drain water from reservoir through float/evaporator drain line

(Fig. 16.3). Reinsert hose into hose clip (Fig. 16.1).

6. Fill reservoir (Fig. 16.2) with Solution B.

7. Restart icemaker and allow gearmotor to run with the

compressor off for 15 minutes.

8. While waiting 15 minutes, follow steps 8a through 8c.

a) Remove ice compression nozzles (Fig. 17.1). Soak in

Solution B.

b) Descale drain pans (Fig. 17.2) by grasping firmly and

gently bending up and down. Vacuum residue out.

c) Inspect all drain lines. Clean as necessary with Solution B.

9. Turn icemaker power off.

10. Drain Solution B through float/evaporator drain line

(Fig. 16.3). Rinse evaporator by filling reservoir (Fig. 16.2) with

potable water and draining evaporator through float/evaporator

drain line (Fig. 16.3) three times. Reinsert hose into hose clip

and plug into end of drain line (Fig. 16.1).

11. Connect ice transport tubes (Fig. 17.3) directly to evaporator

outlet ports (without ice compression nozzle) (Fig. 17.4).

12. Fill reservoir (Fig. 16.2) with Solution A.

13. Turn icemaker power on (to allow gearmotor to run).

14. Wait 10 minutes. Turn compressor switch on.

15. Keep reservoir (Fig. 16.2) full of Solution A while making ice for

20 minutes.

16. Turn compressor switch off.

Fig. 16

Fig. 17