Electrolux # Manuel d'utilisation et d'entretien - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux #. Electrolux # 38 pages. Over the range microwave oven
Également pour Electrolux # : Manuel d'instructions d'installation (8 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (36 pages), Manuel d'utilisation et d'entretien (24 pages), Livre de recettes (17 pages), Livret d'instructions (12 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'instruction (16 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages), Manuel de l'utilisateur (11 pages), Manuel d'utilisation et d'entretien (26 pages), Manuel d'utilisation et d'entretien (38 pages), Manuel du propriétaire (9 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'instructions d'installation (21 pages), Manuel du propriétaire (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'entretien (49 pages)

Imprimer la page
Electrolux # Manuel d'utilisation et d'entretien
18

Getting Started

BEFORE SETTING OVEN CONTROLS

Oven Vent Location
The oven is vented in the backguard.
When the oven is on, warm air is
released through the vent. This venting is
necessary for proper air circulation in the
oven and good baking results.
Oven Rack
Support Screw
Replace
To remove the oven rack supports for a self-clean cycle,
remove the screw located over the rack support on each side,
pull up the support from the oven rack support brackets to
disengage supports from the oven. If the rack supports are not
removed, the self-clean cycle won't start. Always remove the
left side support first. To install oven rack supports insert the
rack supports into the rack support brackets on the oven side
as shown and put back screws at their original location.
Removing Non-Sliding Oven Racks
Simply pull the rack and slightly tilt it upward when the rack hits its stop position.
Replacing Non-Sliding Oven Racks
Insert the rack into the oven rack supports by inserting the rack openings into the rack
supports. Be sure the rack is at the same position on each oven rack support on both sides.
Always arrange the oven racks when the oven is cool (prior to operating the oven). Always use
oven mitts when using the oven.
Oven vent
Remove
Oven Rack
Support Bracket
Installing Oven Rack Supports
ALWAYS INSTALL OVEN
RACK SUPPORT BEFORE
TURNING ON THE OVEN
(WHEN THE OVEN IS COOL).
Removing and Replacing Oven Racks
ALWAYS ARRANGE OVEN RACKS
WHEN THE OVEN IS COOL (PRIOR
TO OPERATING THE OVEN). Always
use oven mitts when using the oven.
To remove an oven rack, pull the
rack forward. Lift up the rack off the
oven rack slider. To replace an oven
rack, place the rack on the slider into
the 4 pinholes located at the 4 corners
of the rack.
Pull oven rack forward and
lift it up of the oven rack
slider.
Insert the openings
into the rack support
Installed
on sliders
To remove
from
sliders
To place on
sliders