BDS EKF 545 Mode d'emploi original - Page 14

Parcourez en ligne ou téléchargez le pdf Mode d'emploi original pour {nom_de_la_catégorie} BDS EKF 545. BDS EKF 545 20 pages. Ekf series 300; ekf series 500; ekf series 600

Imprimer la page

Tool change

Turning the reversing plates

To turn the reversing plates (20, fig. 6),

proceed as follows:

Loosen the side clamping screw (3,

fig. 4).

Unscrew the housing from the motor.

Loosen the fixing screws (21, fig. 6)

with the tools supplied in the scope

of supply, turn the reversing plate an

screw tightly.

Repeat the procedure for all reversing

plates of the miller.

Screw on the housing again.

Tight the clamping screw.

Replacing the reversing plate

When the reversing plate (20, fig. 6) is

completely worn, it must be replaced by a

new one:

Unscrew the Sie fixing screw (21,

fig. 6) with the screwdriver (Torx) and

remove the reversing plate.

Insert the reversing plate and tighten

the fastening screws again.

EKF Series 300/500/600