CommScope TDUX-75 Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} CommScope TDUX-75. CommScope TDUX-75 4 pages. Inflatable duct seal for telephone cable ducts

Imprimer la page

Tooling

TDUX duct seals can be installed with a variety of inflation tools, having the capability to inflate TDUX to 3,0 ± 0,2 bar/45 ± 3 p.s.i. of

pressure. Following tools are available from TE Connectivity.

TDUX-IT-16

Inflation tool using compressed CO

cylinders (to be ordered separately) equiped

with a manometer and safety relieve valve.

5 Installation procedure

5.1 It is recommended to wet clean the duct

and cable sheath.

Right

5.7 In case of 2 cables, wrap TDUX around

the cables as shown, starting with the largest

cable.

gas

CO2 artridge and lubricant.

TC 314/IP/12 08/12

5.2 For ease of installation, lubricate the

cable sheath.

Wrong

5.8 Connect the filling tube to the tube-snap

of the inflation tool.

pressurised air bottle, pump or compressor.

The inlet pressure to the inflation gun should

be min. 4 bar/60 p.s.i. and max.

10 bar/150 p.s.i..

5.3 Remove the protective paper from the

outside of the sealing strip and lubricate abun-

dantly.

5.6 Wrap TDUX around the cable and slide

completely into the duct.

5.9 Inflate TDUX up to the pressure of

3,0 bar/45 p.s.i. and keep the pressure at

3.0 ± 0,2 bar/45 ± 3 p.s.i. during 30 sec.

after which the tool must be shut-off.

Note: please refer to the operating manual for

the specific inflation tool being used.

TDUX-IG-SR-AS

Inflation gun to be connected to