CommScope TDUX-75 Instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} CommScope TDUX-75. CommScope TDUX-75 4 pages. Inflatable duct seal for telephone cable ducts
Imprimer la page5.10 Pull-out the filling tube in one gentle
move in the direction of the cable.
TDUX-CL
Sealing system for multiple telephone cable configurations,
to be used in combination with TDUX inflatable duct seals
Application
TDUX-CL duct seal clip is used in
combination with TDUX inflatable duct seal, if
the duct is occupied with 3 cables or more.
TDUX-CL duct seal clips must be ordered as a
separate item.
For sizing information, please refer to
selection table on the front page.
One TDUX-CL clip can seal up to 4 cables. If
more cables are to be sealed, use
1 extra clip per 3 additional cables.
Installation instruction
1
Open clip wings on one side. Lubricate
the wings abundantly, to ensure that they don't
stick together.
4
Abundantly lubricate the cables in the
crunch area as much as possible.
A
Examples for different multiple cable
configuration.
2
Remove one protection paper and
lubricate abundantly the larger surface of the
clip wing
5
Insert the clip in between the cables,
assuring that there is only one cable between
each clip wing (see picture A "configurations).
Make sure that the central part of the clip is
well positioned in the crunch area (mark flush
with duct entrance).
3
3
Repeat steps 1 and 2 for the other clip
wings. Remove protection paper only after
lubricating at least one wing side.
6
If necessary use a tie-wrap to hold the
clip in place. Cut off the excess of the tie-
wrap and position the locking part between
the cables. Tape all cables together close to
the duct.