Dremel DigiLab 3D45 Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dremel DigiLab 3D45. Dremel DigiLab 3D45 2 pages. Print removal
Également pour Dremel DigiLab 3D45 : Manuel de démarrage rapide (2 pages), Instructions de service (4 pages), Manuel (4 pages), Manuel d'entretien (4 pages), Manuel d'étalonnage (2 pages), Manuel de démarrage rapide (2 pages)

Step 2: Remove build plate from printer

a. Remove the build plate from the printer using the tabs on

right and left side of build plate (shown in picture 1). Place

it vertically against a sturdy surface (shown in picture 2).

b. Ensure the build plate is well secure and will not slip once

object removal tool is being used.

2610038113

Congratulations!

You are now ready to build. Build On.

Step 3: Remove the printed part

a. Place the tip of the object removal tool where the print is

attached to the build plate (shown in the figure below).

b. Give a firm bump on the top part of the object removal tool

(see red arrow).

c. Repeat this process if needed until the part detaches from

the build plate.

08/2018