Dremel DigiLab 3D45 Instruction Manual - Page 2
Browse online or download pdf Instruction Manual for 3D Printers Dremel DigiLab 3D45. Dremel DigiLab 3D45 2 pages. Print removal
Also for Dremel DigiLab 3D45: Quick Start Manual (2 pages), Service Instructions (4 pages), Manual (4 pages), Service Manual (4 pages), Calibration Manual (2 pages), Quick Start Manual (2 pages)
Print Page
Step 2: Remove build plate from printer
a. Remove the build plate from the printer using the tabs on
right and left side of build plate (shown in picture 1). Place
it vertically against a sturdy surface (shown in picture 2).
1.
2.
b. Ensure the build plate is well secure and will not slip once
object removal tool is being used.
2610038113
Congratulations!
You are now ready to build. Build On.
Step 3: Remove the printed part
a. Place the tip of the object removal tool where the print is
attached to the build plate (shown in the figure below).
b. Give a firm bump on the top part of the object removal tool
(see red arrow).
c. Repeat this process if needed until the part detaches from
the build plate.
08/2018