AIRTUG 10-SW Instructions d'assemblage et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et d'utilisation pour {nom_de_la_catégorie} AIRTUG 10-SW. AIRTUG 10-SW 4 pages.

Airtug® /

/ 216-941-9781 / www.airtug.com

Step 1: Install the handle all the way through the second "U"

bolt. Push the handle approximately 1-1/2" beyond the

second "U" bolt. If it appears the handle will not ﬁt through the

"U" bolt, loosen the nuts below. This is a very close tolerance

so the bolt will not interfere with the caster wheel. Once the

handle is installed, tighten nuts securely.

Step 2: The throttle cable and transmission cable are zip tied

to the engine. While holding each cable separately, cut the zip

tie and unravel each cable towards the rear of the tug. Attach

the throttle cable to the right side of the handle using the

fasteners already in the handle with a 5/16" socket.

Step 3: Attach the transmission cable end to the left hand grip

with the "ball" on it. Then open the nuts located several inches

from the hand grip on the cable and slip the cable between

the bracket on the left side of the handle and then secure the

nuts ﬁrmly using an 11/16" wrench.

Note: Using the zip ties provided, secure

both cables to the handle towards the bottom of the handle

loosely.