AOG IRB-18 Manuel d'instructions

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} AOG IRB-18. AOG IRB-18 6 pages. Infrared burner kit

INFRARED BURNER KIT

INSTRUCTIONS

Model # IRB-18

PARTS INCLUDED

1. Infrared burner

2. Igniter wire assembly

3. Self-tapping sheet-metal screw

4. Infrared cover

5. Conversion label

TOOLS REQUIRED

• Phillips screwdriver

•

" open -end wrench

•

" nut driver or socket wrench

REMOVING THE LEFT MAIN BURNER

1. Starting with a cool grill (see caution above), open the oven

lid and remove the rotisserie rod if installed.

2. Remove the cooking grid and ﬂ avor grid from the left-most

burner. Set the cooking grid aside. The ﬂ avor grid will not

be used with the infrared, and should be stored way.

3. Remove the left-most burner by ﬁ rst removing the burner clip

(see Fig. 1-1). Lift the back of the burner up and back (see

Fig. 1-2) so that it pulls out from the forward ﬁ re wall opening

and the oriﬁ ce. Retain the burner clip

use, if desired.

American Outdoor Grill • PO Box 4053 • La Puente, CA 91747

REV 6 - 1607150855

Follow these instructions to install an infrared burner in

your American Outdoor Grill.

CAUTION: Turn each of the burner control knobs to the

OFF position and close the gas shut-off valve

to the grill. Wait for the grill to cool completely

before beginning this procedure.

INSTALLATION

and burner for future

This unit has been retroﬁ tted

Included parts

Burner clip

Fig. 1-1 Remove the grids and burner clip

Fig. 1-2 Remove the burner

NOTE:

with an infrared burner.

L-C2-267