AOG IRB-18 Manuel d'instructions - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} AOG IRB-18. AOG IRB-18 6 pages. Infrared burner kit

INSTALLING THE NEW INFRARED BURNER KIT

1. Locate the new igniter wire assembly with the insulator and

feed the insulated wire through the hole in the forward ﬁ re

wall left by the old igniter box, as shown in Fig. 3-1.

2. Remove the knock-out next to the igniter hole. Attach the

insulated portion of the igniter wire assembly to the inside

of the ﬁ re wall and fasten using the provided screw and the

knock-out hole (see Fig. 3-1 and Fig. 3-2).

3. Position the new infrared burner gas inlet tube in the hole

in the forward ﬁ re wall and over the oriﬁ ce ﬁ tting, sliding it

forward from behind the face frame, so the oriﬁ ce is centered

inside the burner gas tube. Set it gently onto the rear burner

support, making sure the tabs on the back burner bottom

each ﬁ t through their respective slots in the rear burner

support. This is critical to the safe function of the grill. (See

Fig. 3-3 and Fig. 3-4.)

REV 6 - 1607150855

INSTALLATION (cont.)

Bracket

hole

Front ﬁ re

wall

Knock-out

Fig. 3-1 Slide the wire through the ﬁ re wall

Insulator

Igniter

wire

To front

ﬁ re wall

Fig. 3-2 Screw in the new wire insulator

Tabs

Back burner

support

Fig. 3-3 Setting tabs into support

(Infrared burner)

Igniter

electrodes

Gas intake tube

Wire insulator

Oriﬁ ce

(Gas manifold)

Fig. 3-4 Infrared burner installed

Insulated

wire

Hole

L-C2-267