AOG IRB-18 Manuel d'instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} AOG IRB-18. AOG IRB-18 6 pages. Infrared burner kit

4. Connect the bare end of the igniter wire to the bottom of the

electrode assembly on the infrared burner (see Fig. 4-1).

5. Attach the other end of the new igniter wire assembly (the

insulated end) to any connector on the back of the igniter

(see Fig. 4-2).

Important: Test the electrodes for spark before securing the

face to the frame (see also the section on battery

replacement in your manual).

6. Re-install the other ignition wires by plugging them into the

terminals on the igniter module (Fig. 4-2).

7. Afﬁ x the conversion label supplied with this kit to the inside

of the ﬁ re wall behind the control panel so that it does not

obscure any other labels (Fig. 4-3).

8. Reinstall the control panel.

9. Reinstall the drip tray.

10. Replace the cooking grid.

Note: FLAVOR GRIDS ARE NOT TO BE USED with infrared

burners.

REV 6 - 1607150855

INSTALLATION (cont.)

Igniter

electrodes

Front ﬁ re

wall

Fig. 4-1 Connect bare wire to electrode assy.

Original models

Igniter

module

"L" series models

Fig. 4-2 Connect wire to the igniter module

Fig. 4-3 Apply the conversion label

Connect

here

Igniter

wire

Insulator

Igniter

module

L-C2-267