Addvent AVAC12000 Instructions d'installation et manuel de l'utilisateur - Page 15

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel de l'utilisateur pour {nom_de_la_catégorie} Addvent AVAC12000. Addvent AVAC12000 20 pages.

Imprimer la page
Drainage
When the unit is operating in Cooling or Dehumidify ( DRY) mode, humidity
extracted from the air is collected in an internal tank. If the tank reaches full, the
compressor and motor cut out automatically. At the same time, the "Water Full"
indicator comes on. An alarm will also sound. When the tank is full, carry out the
following instructions:
1. Turn off the air conditioner and avoid moving
it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
4. When the container is almost full, replace the
rubber plug in the drain hole and empty the
water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the drain
knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should not be
flashing.
Should you prefer to use the appliance without
having to empty the tank every so often,
proceed as follows :
Remove the drain knob and rubber plug and
retain for future use.
Connect the drain tube supplied to the
water outlet as shown and locate the other
end into a drain.
The drain tube may be extended by adding
an extension tube and using a suitable
connector.
15
FIG 17
FIG 18
FIG 19
FIG 20