ADEMCO Ademco VISTA-20P Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} ADEMCO Ademco VISTA-20P. ADEMCO Ademco VISTA-20P 6 pages. Programming auto arming and disarming schedules
Également pour ADEMCO Ademco VISTA-20P : Manuel d'installation rapide (2 pages), Manuel de programmation (17 pages), Manuel de l'utilisateur (20 pages), Manuel de programmation (17 pages), Manuel d'installation rapide (2 pages), Manuel d'installation rapide (2 pages), Manuel de programmation (2 pages), Manuel rapide (2 pages)

 Summary Screen will appear. Press * to continue or # to go back to make

changes.

 At this time we will not enter Alpha Descriptors. We recommend using *82

for this. (Page 9-1 of the Installation and Setup Guide) Press "0"

 You are ready to enter the next zone. Repeat step 9a for each zone.

NOTE: If you have any unused hardwired zones, these zones should be disabled

using Zone Type 00. Then enter 1 when asked to delete zone. We also

recommend adding a resistor to the zone as well.

When all zones are entered, press 00 at the screen where is asks you for a zone

number to exit.

Step 9b: Wireless Device Zone Programming (*56) (Page 5-1 and 5-7 of the

Installation and Setup Guide)

 Enter *56

 Set to Confirm will be displayed on the screen. This means: Are you

installing wireless devices? Press 1 = Yes

We will be using zones 9-48 (Wireless Transmitter Zones) for this step.

 Enter the Zone Number you wish to program and press *. A summary

screen will be displayed. Press * again to advance past the summary

screen.

 - Enter the Zone Type (ZT). (Refer above or go to page 5-2 in the

Installation and Setup Guide for the exact types). Press * to continue.

 Enter the partition number (PT 1 or 2). (NOTE= Partition 3 is for common

areas between partitions 1 and 2). Then press *.

 Report Code (RC) should be left at 01. The summary will show 10 though

this is correct. Press * to continue

 Enter Input Type

o 2=Aux Wired

o 3=RF Supervised

o 4=UR Unsupervised

o 5=Button type RF transmitter

o Then press * to continue

 You will trip the sensor you are entering. Upon activating the sensor, the

keypad will display the S/N of the device. Confirm that the S/N on the

keypad display and device S/N are both the same by entering "*". If not hit

# and reenter.

 Verify the screen is correct and hit * to continue.

 At this time we will not enter Alpha Descriptors. We recommend using *82

for this. (Page 9-1 of the Installation and Setup Guide) Press "0"

 You are ready to enter the next zone. Repeat step 9b for each zone.