909 909C12V Manuel d'instruction - Page 16
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 909C12V. 909 909C12V 20 pages. 12v variable speed oscillating multi tool
Imprimer la pageNote:
Hold the tool tightly and do not put too much pressure
on the saw blade when cutting.
6. Turn the saw OFF, remove it from the cut and proceed
to cut in the opposite direction to complete the cut for the
first side of the rectangle.
7. Repeat steps 4, 5 & 6 to cut the remaining three sides of
the rectangle.
8. When all cuts are complete, use a flat blade screw driver
to carefully pry the cut-out from the plasterboard.
Note:
Do NOT use the saw blade to pry the cut-out from the
plasterboard. You will break the blade. If the cut-out is not
easy to pry from the plasterboard, check to make sure each
line is cut completely into the corner of the rectangle.
Using the detail sander attachment
1. Install the sanding pad on the oscillating tool as per the
instructions on page 11.
2. Install the sandpaper on the sanding pad.
3. Set the speed control wheel between 4 and 6.
4. Turn the switch ON.
This tool is designed for detail sanding on small surface
areas. Place the sandpaper surface of the sanding pad on
the workpiece to be sanded. Keep the tool moving to avoid
gouging the surface. Use coarse sandpaper and lower
speeds when sanding rough surfaces and for removing
previous finishes. Use fine sandpaper and higher speeds to
produce the smoothest surface.
Using the scraper blade
1. Install the scraper blade on the multi-tool.
2. Set the speed control wheel to #4 and turn the switch ON.
When using the scraper blade to scrape old finishes or glue
from a workpiece, place the under side of the blade flat on
the workpiece surface and then lift upward on the rear of the
tool to allow the blade to form a very slight angle with the
workpiece surface. Feed the blade slowly into the material
that is to be removed. Do not force the tool as slower travel
speeds will produce better cutting action and reduce the risk
of gouging the workpiece.
When using the scraper blade to cut carpet, place a scrap
workpiece under the carpet where the cut is being made.
Set the speed to "6", turn the tool so the scraper blade is at
right angles (perpendicular) to the carpet and then feed the
blade into the carpet.
Maintenance
WARNING:
When servicing, use only identical replacement
parts. The use of any other part may create a hazard or
cause product damage.
DO NOT use solvents when cleaning plastic parts. Plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use a clean
cloth to remove dirt, dust, oil, grease etc.
WARNING:
Do not allow brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. to come into contact
with plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices can damage
the tool and the workpiece.
WARNING:
DO NOT attempt to modify tools or create
accessories. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious injury. It will also void the warranty.
Lubrication
All of the bearings in this tool are lubricated with a sufficient
amount of high-grade lubricant for the life of the unit under
normal conditions. Therefore, no further lubrication is
required.
16