909 909C12V Manuel d'instruction - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 909C12V. 909 909C12V 20 pages. 12v variable speed oscillating multi tool
Imprimer la pageand red. When the green light goes out leaving the yellow
and red, the battery level is approx 1/2 to 3/4 charge. When
the yellow light goes out, leaving just the red, the charge
level is approx 1/4 charged, and is recommended to stop
work and re charge.
Speed control wheel
The speed of the tool can be adjusted to run the tool at
speeds varying between 5,000 OPM and 19,000 OPM by
rotating the speed control wheel located toward the rear of
the tool housing.
1. To increase the speed, rotate
the speed control wheel (2)
Clockwise toward the right
side of the tool.
2. To decrease the speed,
rotate the speed control
wheel (2) Anti Clockwise
toward the left side of the
tool.
Note:
Speed #1 is the lowest speed. #6 is the highest
speed.
The optimal speed setting will vary depending upon the type
of accessory being used, the surface being worked and the
complexity of the project. For general recommendations,
see the chart below.
Project
Accessory
Door jamb
Wood blade
Door casing
Wood blade
Wood dowels
Wood blade
Floor vent
Wood blade
PVC pipe
Wood blade
Glued flooring
Scraper
Sanding
Sander
Flush cutting a door jamb and casing for
installing flooring
The oscillating
tool can be used
to flush cut a door
jamb and casing
to allow space for
the new flooring
to fit neatly under
the door jamb
and casing. For
the purpose of
demonstrating the
procedure, floor tile
is being used.
1. Install the plunge cutting wood saw blade for wood in the
tool.
Note:
NOT installed in the 90° position.
2. Place a scrap piece of floor tile (1) on the floor about 1/2"
(12 mm) from the door jamb (2).
Note:
to provide a smooth surface for the blade to follow.
3. Place the tool with the saw blade (3) lightly touching the
surface of the tile and the cutting teeth NOT touching the
surface to be cut.
Speed
4. Set the speed to the fastest speed and turn the tool ON.
Maximum
5. When the tool reaches its maximum set speed, carefully
Med / max
plunge the blade into the door jamb while sliding the
blade along the floor tile.
Maximum
Note:
Med / max
pressure on the saw blade when cutting, as this will cause
Medium
the tool to vibrate excessively.
Medium
6. Continue to make several plunge cuts until the bottom of
the door jamb and casing are completely cut off and the
Med / max
loose pieces can be easily removed.
14
The blade should be centred on the tool housing and
Make sure the "good" side of the tile is facing upward
Hold the tool tightly and do not put too much forward