909 909C12V Manuel d'instruction - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 909C12V. 909 909C12V 20 pages. 12v variable speed oscillating multi tool
Imprimer la pageIf the green light does not come on and the red light is
illuminated on the adaptor, the cells are not charging and
the cells require some time to cool.
DO NOT force cool the pack.
1. To install the battery pack on
the charger adaptor, align the
battery pack with the charger
base and insert firmly into
place.
Note:
If the battery pack is
incorrectly orientated the battery
will not fully enter the base as
depicted.
2. Plug the charger into the
charger base and plug in
the charger and switch on at
the power supply. The green
LED indicator located on the
charger base will indicate that
the battery is being charged.
The red light on the base
indicates that there is power
to the charger base. This red
light is a power indicator and
will glow whenever power is
supplied to the base.
3. The battery charging time
is approximately 3-5 hours.
When the green LED goes
out leaving the red LED
glowing the charging cycle is
complete.
4. Turn off the charger power supply from the mains and then
remove the battery pack from the charger base.
Both the battery pack and the charger may become warm
to touch. This is also normal and not an issue of concern.
Both the battery pack and charger are fitted with thermal
safety devices and they will shut down if the temperatures
become too high.
To obtain the best life for the battery
Never allow the oscillating tool to come to a complete stand
still before recharging. The battery should be placed on
charge whenever the battery is noticeably running down or
the oscillating tool no longer performs a task it previously
performed. For storage, charge between 50 and 75%. Avoid
allowing lose items like screws or nails etc. to be stored with
battery packs as these or similar items can short battery
packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
On/off switch
1. To turn the tool ON, slide the ON/OFF switch (1) toward
the front of the tool. The LED work light will switch
on during tool operation and switch off when not in
operation.
2. To turn the tool OFF, slide the ON/OFF (1) switch toward
the rear of the tool.
Battery charge indicator.
The oscillating tool is provided
with a small 3 level battery level
indicator. Three LED's on the
left side of the housing, above
the speed control dial indicate
the approx battery level. On a
full battery the three lights will
glow, showing Green, yellow
13