909 909C12V Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 909C12V. 909 909C12V 20 pages. 12v variable speed oscillating multi tool

Imprimer la page

1. Battery Charging

Installing accessories

All accessories supplied are installed on the oscillating tool

in a similar manner. For the purposes of describing the

accessory installation, the plunge cutting blade is used.

WARNING: Disconnect battery pack from oscillating tool or

place the switch in the locked or off position before making

any assembly, adjustments or changing accessories. Such

preventive safety measures reduce the risk of starting the

tool accidentally.

1. Remove the outer flange screw (11) from the outer flange

(10) by turning the screw counter clockwise. Use the

5mm hex key if the screw is too tight to be removed by

hand.

2. Remove the outer flange (10).

3. Place the plunge cutting blade

onto the inner flange (12).

Note:

the inner flange has

multiple notches that enables

you to position the plunge

cutting blade where required.

The blade can be mounted at

various angles left or right of

centre if required.

4. When you have selected

the location for the plunge

cutting blade, place the outer

flange (10) on top with the

depressed end showing

outwards.

5. Insert the outer flange screw

(11) into the outer flange

(10), and using the 5mm

hex key tighten the screw in

a clockwise direction until it

is finger tight.

Using the accessory

adaptor to install

other branded accessories

1. The accessory adaptor (9) is used for accessories that

are not 909 branded. This includes Bosch, Dremel and

WorX accessories with an inner circular bore of 10mm

diameter.

WARNING:

DO NOT use

accessories with the accessory

adaptor with a diameter of less

than 10mm.

2. Remove the outer flange

(10) by loosening the outer

flange screw (11) using the

5mm hex key in a counter

clockwise direction.

3. Once the outer flange (10) is removed place the

accessory adaptor (9) over the inner flange (12) fitting the

depressed pentagon over the raised pentagon fitting on

the inner flange (12).