909 909C12V Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 909C12V. 909 909C12V 20 pages. 12v variable speed oscillating multi tool

Imprimer la page
Another feature of the drill/battery pack is the low voltage
cut out feature. This feature operates when the voltage
drops below a pre set value. When this occurs the tool will
automatically stop operating. To correct the situation you
need to either insert another charged battery into the drill
or recharge the existing battery, and then proceed with the
drilling/driving application.
Note:
Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to drill restarting and then stopping again
after only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.
When to charge the battery
New batteries are shipped in a low charged condition and
should be fully charged before Use.
The battery pack can be recharged at any time during use,
provided the pack is not overheated.
If the battery pack starts to cut out due to low voltage, or
previous tasks undertaken can no longer be performed, it is
suggested to stop using the tool and recharge the battery.
For storage, it is suggested to recharge the battery between
50% and 75% charge. 1 hour using the fast 1 hour charger
after the battery pack has been used and charged a few
times.

Accessories

1 x Flat Scraper Blade
1 x Flat Cutting Blade
1 x Accessory Adaptor
1 x Sanding Pad with Hook & Loop Base Sanding Sheets:
1 x 80g, 1 x 120g, 1 x 180g
1 x Hex Key
WARNING:
Use only accessories that are recommended for
this oscillating tool. Follow the instructions that accompany
the accessories. The use of improper accessories may result
in injury to the operator or damage to the tool.
Before using any accessory, carefully read the instructions
or the owner's manual for the accessory.
WARNING:
If any part is missing or damaged, do not plug
the tool into the power source or install any accessory until
the missing or damaged part is replaced.

Unpacking

Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
9