909 KSBL26CCG Manuel d'instruction - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 KSBL26CCG. 909 KSBL26CCG 15 pages. 26cc full crank key start petrol blower

Imprimer la page

Blowing

Start the blower engine, as previously described. Hold the
blower firmly about 10–20 cm from the ground and move it
in a sweeping motion from
left to right, directing the debris to the desired location.
•
Use low throttle settings when clearing lightweight
materials from around lawns or shrubbery.
•
Use medium to higher throttle settings to move
lightweight grass or leaves from driveways or paths.
•
Use full throttle when moving heavy loads such as dirt or snow.
IMPORTANT.
Blower noise increases at higher throttle
settings. Always use the lowest throttle setting required to
get the job done.
•
Never operate the blower unless it is properly assembled
and in good working condition.
•
Never operate the blower without a properly functioning
muffler and spark arrestor installed.
When to recharge the batteries
It is recommended the batteries are recharged fully every
3 months regardless of the amount of times the blower is
used.
During the months of use it is suggested to recharge the
batteries after 20 – 30 starts although the batteries are
capable of starting the trimmer in excess of 100 starts per
charge, but this can depend on the starting conditions.
It should be noted that the batteries are NOT recharged
while the blower is being used and the only method for re
charging is with the supplied external plug pack charger.
NOTE:
DO NOT attempt to start the blower with the battery
charger connected

Use of the petrol blower

•
The petrol blower can efficiently move a wide variety
of debris ranging from grass clippings to gravel. As
a general rule try to operate the blower at the lowest
throttle setting necessary to get the job done.
•
Prior to use of the blower ensure you have read and
understood this instruction manual.
•
Ensure you are wearing suitable clothing and also safety
equipment like safety glasses, ear protection and a mask
if necessary.
•
Keep a gap between the air intake and clothing and body
parts as blocking the intake will reduce the performance
of the blower and may result in injury.

Maintenance

WARNING. Before performing any maintenance on this
blower, stop the engine and disconnect the spark plug wire.
Checking the spark plug
Check the spark plug every 10–15 hours of use.
1. Remove the spark plug cover.
2. Use a spark plug wrench to remove the spark plug,
by turning it counter-clockwise.
3. Clean and adjust the spark
plug gap to 0.6–0.7mm.
Replace any damaged or
visibly worn plug with a
Champion RCJ6Y, NGK
BPM6A or equivalent spark plug.
12