Gallagher T20 Note d'installation - Page 5
Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Gallagher T20. Gallagher T20 14 pages.
Imprimer la page
Installation Note
5.
Secure the tamper tab (located in the base) to the mounting surface using
remaining fixing screw provided.
6.
Connect the reader tail extending from the facia assembly to the building
cable. Connect the wires, as shown in the following diagram.
Note: Do not cut the "Reserved" wires, as they may be used for future
functions.
7.
Fit the facia assembly into the base by clipping the small lip, into the top of the
base and holding the top, press the bottom of the facia assembly down into
the base.
8.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security
screwdriver) through the hole at the bottom of the base to secure the facia
assembly.
Note: The Torx Post Security screw needs only to be lightly tightened.
The recommended torque for the security screw is 0.7 Nm (0.5 lb/ft). It is
important not to exceed the maximum torque of 1.5 Nm (1.1 lb/ft).
Document Code: 3E3140
Edition 3, April 2013
No. 6 pan head screw
Positive
Negative
Reserved
Reserved
Reserved
CDXIV TX
CDXIV RX
Red
Black
Orange
Green
Brown
White
Blue
Gallagher T20 Reader
Base
Tamper tab
Building cable
Page 5