Coram TUBULAR SHOWER PANELS Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Coram TUBULAR SHOWER PANELS. Coram TUBULAR SHOWER PANELS 9 pages.

Imprimer la page

a: Assemble the strut: Slide on the outer ceiling bracket and panel bracket. Lightly tighten the fitted grub screws.

b: Carefully place the strut assembly onto the glass, approximately 100mm from the edge (depending on your installation). Ensure the strut is vertical and mark the

position of the outer ceiling bracket onto the ceiling.

c: Remove the strut assembly. Drill a hole in the centre of the position marked using a 6mm drill bit, 30mm deep.

d: Insert the wall plug and fix the inner ceiling bracket to the ceiling using a 32mm screw and washer. Note: The opening in the inner ceiling bracket should be

parallel with the end of the panel.

Note: The screws and wall plugs supplied are for masonry walls. For lightweight walls i.e. stud partitions, plasterboard etc, use the correct type of fixings.

Push-fit the top cap onto the top of

From outside only, From outside only, apply silicone

the wall channel.

sealant along the bottom of the panel as shown.

ø 6

100

Outside

32mm

a: Reposition the strut back onto the panel (with grub screws on the inside). Angle the top end into

the inner ceiling bracket, slide the outer ceiling bracket up the strut and screw onto the inner ceiling

bracket.

b: Lightly tighten the grub screw on the outer ceiling bracket.

c: From inside, slide the glass clamp up between the bracket and glass panel and tighten the grub

screw.

Ensure the strut is vertical and fully tighten both grub screws.

Inside

PAGE 4