Major Manufacturing HIT-30L-125 Manuel d'instructions - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Major Manufacturing HIT-30L-125. Major Manufacturing HIT-30L-125 12 pages. Template for adams rite 2190 lock

Imprimer la page

Once the faceplate has been cut out it is time to start drilling the function

holes. Starting at the top, drill the inside and outside holes with a 1-1/4"

hole saw. If retrofitting, drill these holes to clean up any misalignment.

There are three holes inside and outside to drill next. The factory template

calls for a .196 diameter drill bit. Our drill guides will accept a 13/64" twist

drill, a lot easier to find in the field. The bottom holes shown being drilled

on the right is a pilot hole that will be drilled later.