Major Manufacturing HIT-30L-125 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamki Major Manufacturing HIT-30L-125. Major Manufacturing HIT-30L-125 12 stron. Template for adams rite 2190 lock
Drukuj stronęOnce the faceplate has been cut out it is time to start drilling the function
holes. Starting at the top, drill the inside and outside holes with a 1-1/4"
hole saw. If retrofitting, drill these holes to clean up any misalignment.
There are three holes inside and outside to drill next. The factory template
calls for a .196 diameter drill bit. Our drill guides will accept a 13/64" twist
drill, a lot easier to find in the field. The bottom holes shown being drilled
on the right is a pilot hole that will be drilled later.