Major Manufacturing HIT-30L-125 Petunjuk Manual - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Kunci Major Manufacturing HIT-30L-125. Major Manufacturing HIT-30L-125 12 halaman. Template for adams rite 2190 lock
Once the faceplate has been cut out it is time to start drilling the function
holes. Starting at the top, drill the inside and outside holes with a 1-1/4"
hole saw. If retrofitting, drill these holes to clean up any misalignment.
There are three holes inside and outside to drill next. The factory template
calls for a .196 diameter drill bit. Our drill guides will accept a 13/64" twist
drill, a lot easier to find in the field. The bottom holes shown being drilled
on the right is a pilot hole that will be drilled later.