decorflame M100-25FAO Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} decorflame M100-25FAO. decorflame M100-25FAO 12 pages. Electric fireplace heater

Imprimer la page

1. Drill a 5/16" (8 mm) hole in the wall. Insert

the PLASTIC WALL ANCHOR into the hole

and gently tap until the flange on the anchor

is against the wall surface.

2. Position the back edge of the mantel close

to the wall.

3. Attach the SAFETY CABLE to the mantel

using the SCREW FOR MANTLE. See fig. I

4. Use the SCREW FOR WALL to attach the

other end of SAFETY CABLE to the wall.

5. Make sure all screws are tight.

After reading complete instructions, confirm

all controls on fireplace are in the OFF posi-

tion. Plug the fireplace into a 15AMP/120Volt

outlet. If the cord does not reach, you may

use an extension cord rated for a minimum

of 1875 WATTS. Once the fireplace insert

has been properly connected to a grounded

electrical outlet, it is ready to operate.

O P E R A T I O N

Fig. I

OPERATION BY

THE CONTROL PANEL

The controls are located behind the grill

below the front glass and can be accessed

by pulling the grill from the top, forward and

down.

O/I: Press this button for main power and

flame effect. The indicator light will turn on.

See below for other control switches.

1250W: For heat function - Press this switch

while the O/I switch is in the ON position. The

indicator light will turn ON.

Temperature Control: To adjust the tempera-

ture to your individual requirements, turn the

temperature control dial to the right (clock-

wise) to increase the desired temperature

and to the left for lower temperature. This

temperature control dial can only be used

while the O/I switch and 1250W switch are in

the ON position.