a-TroniX Jump starter Booster 12V 4000A Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} a-TroniX Jump starter Booster 12V 4000A. a-TroniX Jump starter Booster 12V 4000A 15 pages.
Imprimer la page
Instruction Manual
Jump starter Booster 12V 4000A
7. Forced start for batteries with a
voltage below 6 V
This mode is recommended when starting a vehicle with a fully discharged, extremely
discharged, missing, or switched-off battery.
CAUTION:
SOME SECURITY FUNCTIONS ARE DISABLED,
PLEASE BE CAREFUL WHEN USING THE JUMPER.
Check that the jump starter is switched off.
■
Identify the vehicle's ground terminal; usually it is connected to the negative terminal.
■
Always connect the output conductor with red pliers (+) to the positive pole of the
■
battery and the output conductor with black pliers (-) to the vehicle ground.
Never reverse the polarity; this can cause explosions, damage to the vehicle, to the
■
device and to people.
If the LED ROT / REVERSE lights up, the polarity has been reversed. Disconnect the
■
battery terminals from the vehicle and connect them properly.
Make sure the cables are out of the reach of fans, moving parts, and the fuel line.
■
Press the START / STOP button for 7 seconds, then the blue LED turns on and
■
the word „STRT" flashes on the display. From now on some protective devices are
deactivated.
Start the engine within 30 seconds.
■
The jump starter switches off automatically after 30 seconds.
■
CAUTION:
IMMEDIATELY AFTER STARTING THE ENGINE, SWITCH OFF THE STARTING
AID AND DISCONNECT THE PLIERS.
To switch off, press the START / STOP button.
■
First disconnect the output conductor from the vehicle ground with black pliers (-) and
■
immediately store it in its holder.
Then disconnect the output conductor from the positive pole (+) of the battery with red
■
pliers and also immediately store it in its holder.
If it is not possible to start the vehicle with the first few attempts, under no
■
circumstances should you continue with further attempts. Before restarting, the device
should rest for at least 3 minutes so that it is not damaged.
Charge the jump starter after each use.
■
09/2021
Page 11