a-TroniX Jump starter Booster 12V 4000A Manuel d'instruction - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} a-TroniX Jump starter Booster 12V 4000A. a-TroniX Jump starter Booster 12V 4000A 15 pages.
Imprimer la page
Instruction Manual
Jump starter Booster 12V 4000A
8. 12 V MEMORY SAVER
CAUTION:
Some safety functions are deactivated in the „MEMORY SAVER" operating mode.
Use caution when using the jump starter.
Check that the device is switched off.
■
Always check the voltage of the vehicle battery.
■
The mismatch between the voltage of the jump starter and the voltage of the vehicle
■
system can cause explosions, damage to the vehicle, to the device and to people.
Identify the vehicle's ground terminal; usually it is connected to the negative terminal.
■
Always connect the output conductor with red pliers (+) to the positive pole of the
■
battery and the output conductor with black pliers (-) to the vehicle ground. From now
on some protective devices are deactivated.
Never reverse the polarity; Reversing the polarity can cause explosions, damage to the
■
vehicle, to the jump starter and to people.
If the LED ROT / REVERSE lights up, the polarity has been reversed. Disconnect the
■
battery terminals from the vehicle and connect them properly.
Disconnect the pliers from the vehicle and connect them correctly.
■
Make sure the cables are out of the reach of fans, moving parts, and the fuel line.
■
Press the START / STOP button for 5 seconds, then the blue LED and the yellow LED
■
turn on and the word „MEMO" appears on the display.
Start with the intended activities.
■
When you have finished, press the START / STOP button to switch off the device.
■
CAUTION:
Recharge the emergency starter after each use.
CAUTION:
The following operations must not be carried out with the „MEMO" function:
Do not use the „MEMO" function to start vehicles.
■
With the „MEMO" function, the jump start does not switch off after 30 seconds.
■
Before disconnecting the pliers, make sure that the jump start is switched off.
■
At the end of the work process, keep the jump starter in a dry place without moisture.
■
Use a dry cloth to clean the outer housing.
■
Page 12
09/2021