Dell 3250 Manuel du produit - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Dell 3250. Dell 3250 37 pages. Product guide (.pdf)
Également pour Dell 3250 : Information Update (32 pages), Manuel du propriétaire (39 pages), Manuel du propriétaire (39 pages), Manuel de démarrage rapide (2 pages)

Imprimer la page

Beep Codes

10.1 Recovery Beep Codes

These audible codes describe the progress of a BIOS recovery attempt from a recovery CD

refer to chapter 11 Clearing CMOS and BIOS recovery for detail and steps to perform this

process.

Beeps

1 short

2 short

Repeating

10.2 BMC Beep Code Generation

The BMC generates beep codes upon detection of the failure conditions, each digit in the code

is represented by a sequence of beeps whose count is equal to the digit.

Code

1-5-1-1

FRB3 failure (processor failure)

1-5-2-1

Processor: Empty Slot

1-5-2-2

Processor: No Processors

1-5-2-3

Processor: Configuration Error (e.g., VID mismatch)

1-5-4-2

Power fault: DC power unexpectedly lost (power

control failures)

1-5-4-3

Chipset control failure

1-5-4-4

Power control fault

Table 8. Recovery Mode Beep Codes

Medium tone BIOS Flash Update Started

Medium tone BIOS Flash Update Complete

Low tone BIOS Recovery Error Occurred, or no recovery media found

Table 9. BMC Beep Codes

Reason for Beep

Intel® Server Platform SR870BH2

Description

Course of action

See "FRB" in Debug Methodology and failure

Isolation section.

No processor found in socket 1, See "Processor" in

Debug Methodology and failure Isolation section.

No processor found in socket 1, See "Processor" in

Debug Methodology and failure Isolation section.

General Processor Issue, See "Processor" in

Debug Methodology and failure Isolation section.

DC Voltage error, (1) check TPS power supply (s)

for amber lights – replace if found (2) Check /

replace power cage.

DC Voltage error, or dead short (MOST Common

cause) i.e. DC to GND (1) check TPS power supply

(s) for amber lights – replace if found (2) Check

Flex Cable for damage (nick in housing) or poor

connection – reseat cable or replace, check all

board to board connections i.e. VHDM connectors

(Riser to main board) carefully look for Bent or

flattened pins at end of connector near fans (3)

Check / replace power cage.

Revision 1.1