Dell PowerEdge 4400 Manuel d'installation - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 4400. Dell PowerEdge 4400 28 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 4400 : Manuel d'installation (42 pages), Manuel d'installation (20 pages), Installation du rack (37 pages), Manuel de mise à jour (8 pages), Information Update (8 pages), Manuel de l'utilisateur (42 pages), Installation du rack (34 pages), Manuel d'installation du matériel (40 pages), Manuel d'installation (36 pages), Manuel (15 pages)

support.dell.com

To replace the 24-U rack's front and back doors, perform the following steps:

Lift the front door into position, and align the hinges with the hinge insert in the

rack as shown in Figure 1-4.

Slide the hinge pins into the hinge insert in the rack until the hinges lock into

position.

Repeat steps 1 and 2 to install the back door.

Installing the Rubber Feet

To install the rubber feet on the system base, perform these steps:

Lay the system on its left side (see Figure 1-11) on a piece of foam or cardboard

(to prevent damage to the system).

Attach a rubber foot in each of the four corners on the cabinet base (the cabinet's

right side in the former rack configuration) using an 8-32 x 0.5-inch hex-head,

thread-forming screw (screws and rubber feet at provided with the kit), as shown

in Figure 1-11.

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide

8-32 x 0.5-inch screw

rubber feet (4)

1-13