Diamond IBERICA/CG-80 Instructions techniques d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Instructions techniques d'installation pour {nom_de_la_catégorie} Diamond IBERICA/CG-80. Diamond IBERICA/CG-80 17 pages.

Imprimer la page

TECHNICAL INSTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE

a. Unscrew and remove the protective stainless steel front panel.

b. Unscrew the nut of the inlet and outlet gas pipe.

c. Unplug the connections.

d. Install the new spark control or solenoid valve and adjust.

e. Put the connections into place again as they were.

Make sure the unit is perfectly gastight before operating it again.

 Engine

a. Remove the front panel of the fryer.

b. Remove the electrical connection.

c. Remove the gas connection.

d. Unscrew the burner unit and take it out.

e. Replace the engine.

Install the connections again.

 Pressure switch

a. Remove the front panel of the fryer.

b. Unscrew the nut of the inlet and outlet gas pipe.

c. Remove the connection.

d. Remove the silicone pipe.

e. Unscrew the pressure switch.

Replace the pressure switch.

g. Install the components and pipe again.

REMARK: Make sure the pressure switch has a value of "60".

 Main burner

a. Remove the front panel of the fryer.

b. Remove the electric connection of the motor.

c. Unscrew gas connection.

d. Unscrew and remove the burner in its whole.

e. Unscrew and remove the electrode.

Replace the burner.

g. Install connections again.

 Electronic regulation thermostat

VERY IMPORTANT: NEVER MANIPULATE THE ELECTRONIC THERMOSTAT. THE

THERMOSTAT HAS BEEN CONFIGURED AT THE FACTORY AND IS PROTECTED

WITH A SECURITY CODE.

a. Remove the clamps that fasten the thermostat to the front.

b. Remove the wires from the thermostat.

c. Install the new thermostat in the same place.

9 / 16