Diamond IBERICA/CG-80 Instructions techniques d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Instructions techniques d'installation pour {nom_de_la_catégorie} Diamond IBERICA/CG-80. Diamond IBERICA/CG-80 17 pages.

Imprimer la page

TECHNICAL INSTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE

3.3.

GAS CONNECTION

Before connecting the fryer, consult your gas supplier and check whether your gas network

supplies the necessary pressure and flow in order to ensure a proper operation of the fryer.

This device is equipped with a gas connection threaded ½" in accordance with norm EN

10226. A seal can be placed on the end if necessary.

The plate next to the gas connection indicates the gas type for which this fryer is

configured.

Check the gas pressure at the inlet. Since pressure loss by the gas network is possible, it

is advisable to install a pressure regulator or stabilizer to prevent the inlet pressure to the

fryer to exceed the pressure indicated on the plate (see Chapter 2 – Technical Information).

This gas appliance must be installed by authorized personnel. Both rigid and flexible non-

metallic pipes may be used according to norm EN 53539 or flexible metallic pipes according

to norm EN 14800. Pipes should never exceed the length of 1,5 mt. If rigid pipes are used,

then a stopcock must be installed as close as possible to the fryer's connection.

Connect the fryer to the gas network according to the current regulations.

installation is completed, check with soapy water or a manometer that the pipes are leak

proof.

Never use a flame to verify if there are leaks.

In case you wish to connect the fryer to a gas bottle, make sure the bottle is always in

vertical position and it complies with following characteristics:

NOTE: install a gas pressure regulator on gas bottles in order to ensure an adequate

pressure.

3.4.

START-UP

 Nominal thermal power control

Thermal power of the device must be verified by an authorized technician according to the

indications described in this manual after every maintenance operation, in case of new

installation or if the device is converted to a type of gas different than that for which it was

configured originally.

Nominal thermal powers for each model are indicated on the chart of Chapter 2. - Technical

Information).

TYPE

BUTANE

Domestic

PROPANE

Industrial

PROPANE

GAS

CAPACITY

12,5 KG

11,0 KG

35,0 KG

Once the

7 / 16