Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

To remove the MSFC2 from the supervisor engine, follow these steps:

Step 1

Upload the current configuration to a server. On any modules running Cisco IOS software, save the

running configuration.

Remove the supervisor engine from the Catalyst 6500 series switch. (Refer to the Catalyst 6500 Series

Step 2

Module Installation Guide for removal instructions.)

Place the supervisor engine on an antistatic mat or foam.

Step 3

Remove the securing screws and cap nut that secure the MSFC2 to the supervisor engine. (See

Step 4

for an MSFC2 shipped before November 2001, or see

2001.)

Note

Figure 1

Hold here

78-14357-02

The MSFC2 shipped after November 2001 is physically smaller than the previous MSFC2 and

is not secured with a cap nut. (See

MSFC2 Shipped Before November 2001—Removing Securing Screws and Cap Nut

Hold here

SWITCH LOAD

WS-X5530

100%

SUPERVISOR ENGINE I I I

CONSOLE

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Figure 2

for an MSFC2 shipped after November

Figure

2.)

Removing the MSFC2

Figure 1