Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Removing the MSFC2

Figure 2

Hold

here

Hold the top edge of the MSFC2 with your right hand and the bottom-left edge with your left hand.

Step 5

(See

Figure 1

November 2001.) Gently lift the MSFC2 with both hands simultaneously, and remove the MSFC2 from

the supervisor engine.

Caution

Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will

have to return the supervisor engine to Cisco for repair.

Place the MSFC2 on an antistatic mat or antistatic foam pad.

Step 6

Proceed to the

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

MSFC2 Shipped After November 2001—Removing Securing Screws

Hold here

SWITCH LOAD

WS-X5530

100%

SUPERVISOR ENGINE I I I

CONSOLE

for an MSFC2 shipped before November 2001 or

"Upgrading the DRAM DIMM" section on page 7

Figure 2

for an MSFC2 shipped after

to install the DRAM.

78-14357-02