Cisco Profile Series Manuel d'installation - Page 29

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco Profile Series. Cisco Profile Series 44 pages. Jbod on the 12g sas modular raid controller
Également pour Cisco Profile Series : Manuel de démarrage (41 pages), Manuel de l'utilisateur (44 pages), Manuel de l'utilisateur (7 pages), Manuel de démarrage (35 pages), Manuel de référence rapide (2 pages), Manuel de configuration (13 pages), Fiche d'installation (2 pages), Manuel d'installation (2 pages), Manuel de démarrage rapide (4 pages), Manuel de démarrage rapide (4 pages), Manuel d'installation (16 pages), Manuel de démarrage (32 pages), Manuel (16 pages), Manuel de démarrage (42 pages), Manuel de démarrage (46 pages)

Cisco Profile Series Manuel d'installation
Chapter 2
Installing the Router
If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws
Step 7
provided and the green or green and yellow striped wire. Connect the other end of the wire to the vehicle
ground.
After you install and properly ground the router, you can connect the power wiring, the LAN cables, and
the cables for administrative access as required for your installation.
Installing the Power Cord Retention Latch
The Cisco 800M Series ISR has a power cord retention mechanism as a accessory. It locks the power
cord to the router. When a user accidentally pulls on the power cord, the power cord will not come out
from the router.
This section describes how to install the power cord retention lock.
Place the power cord lock onto the power cord, as shown in
Step 1
then pull the plug back to seat in the lock.
Figure 2-8
Install the power cord with power cord lock and the pre-installed o-ring to mate with the power jack on
Step 2
the router. Make sure that the two arms of the power cord lock slide into the corresponding slots on the
router and are fully seated with both arms locking into the slots as shown in
Figure 2-9
Place the Power Cord Lock onto the Power Cord
Installing Power Cord Lock onto the Router
Cisco 800M Series Integrated Services Router Hardware Installation Guide
Figure
2-8. The cable slides into the slot and
Figure
2-9.
1
2-9