Cisco Profile Series 설치 매뉴얼 - 페이지 29

{카테고리_이름} Cisco Profile Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Profile Series 44 페이지. Jbod on the 12g sas modular raid controller
Cisco Profile Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (7 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 구성 매뉴얼 (13 페이지), 설치 시트 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (16 페이지), 시작하기 매뉴얼 (32 페이지), 매뉴얼 (16 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

Chapter 2

Installing the Router

If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws

Step 7

provided and the green or green and yellow striped wire. Connect the other end of the wire to the vehicle

ground.

After you install and properly ground the router, you can connect the power wiring, the LAN cables, and

the cables for administrative access as required for your installation.

Installing the Power Cord Retention Latch

The Cisco 800M Series ISR has a power cord retention mechanism as a accessory. It locks the power

cord to the router. When a user accidentally pulls on the power cord, the power cord will not come out

from the router.

This section describes how to install the power cord retention lock.

Place the power cord lock onto the power cord, as shown in

Step 1

then pull the plug back to seat in the lock.

Figure 2-8

Install the power cord with power cord lock and the pre-installed o-ring to mate with the power jack on

Step 2

the router. Make sure that the two arms of the power cord lock slide into the corresponding slots on the

router and are fully seated with both arms locking into the slots as shown in

Figure 2-9

Place the Power Cord Lock onto the Power Cord

Installing Power Cord Lock onto the Router

Cisco 800M Series Integrated Services Router Hardware Installation Guide

Figure

2-8. The cable slides into the slot and

Figure

2-9.

2-9