Cisco Profile Series Installation Manual - Page 29

Browse online or download pdf Installation Manual for Conference System Cisco Profile Series. Cisco Profile Series 44 pages. Jbod on the 12g sas modular raid controller
Also for Cisco Profile Series: Getting Started Manual (41 pages), User Manual (44 pages), User Manual (7 pages), Getting Started Manual (35 pages), Quick Reference Manual (2 pages), Configuration Manual (13 pages), Installation Sheet (2 pages), Installation Manual (2 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages), Installing Manual (16 pages), Getting Started Manual (32 pages), Manual (16 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Cisco Profile Series Installation Manual
Chapter 2
Installing the Router
If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws
Step 7
provided and the green or green and yellow striped wire. Connect the other end of the wire to the vehicle
ground.
After you install and properly ground the router, you can connect the power wiring, the LAN cables, and
the cables for administrative access as required for your installation.
Installing the Power Cord Retention Latch
The Cisco 800M Series ISR has a power cord retention mechanism as a accessory. It locks the power
cord to the router. When a user accidentally pulls on the power cord, the power cord will not come out
from the router.
This section describes how to install the power cord retention lock.
Place the power cord lock onto the power cord, as shown in
Step 1
then pull the plug back to seat in the lock.
Figure 2-8
Install the power cord with power cord lock and the pre-installed o-ring to mate with the power jack on
Step 2
the router. Make sure that the two arms of the power cord lock slide into the corresponding slots on the
router and are fully seated with both arms locking into the slots as shown in
Figure 2-9
Place the Power Cord Lock onto the Power Cord
Installing Power Cord Lock onto the Router
Cisco 800M Series Integrated Services Router Hardware Installation Guide
Figure
2-8. The cable slides into the slot and
Figure
2-9.
1
2-9