Cablematic WL2001 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cablematic WL2001. Cablematic WL2001 5 pages. Gsm emergency alarm system

Imprimer la page

Well SEC Electronic Co.,Ltd

Ⅰ.General information:

1. Adopt GSM communicator, no distance limit to alarm.

2. Support GSM/CDMA mobile phone.

3. Can per-set 5 phone numbers of user/ police/ monitoring center (no longer than 16 character each

number). If an alarm occurs, numbers will be dialed in order.

4. Remotly arm, disarm, panic alarm

5. Control the system by a mobile phone anywhere, anytime.

7. For weak GSM signal area an external antenna can be used.

10. Easy to be installed and operated.

11. Built-in battery can continue to work for 8~10 hours.(in the further)

12. No need for fixed telephone line, only GSM Network is present,so is very suitable for cottage, house,

shop, garage, etc.

Ⅱ.Installation guide:

1. Insert SIM card in main panel

Open the back cover. And insert the SIM card.

Attention! Metal contacts of the SIM must be down. Check it to be inserted correctly. Before insert

SIM card in the host, using a mobile phone to do the following steps:

Set PIN code request to off

Delete all stored phone numbers

Store for phone numbers (up to 5 numbers), which will be dialed out in sequence when alarming.

2. Coding wireless sensors (Registering wireless sensors with alarm host)

Add a new sensor (remote controller/wireless door sensor, wireless PIR detectors) to the

system:

Plug on 12V supply at alarm system

STATUS light will change from orange to green (reaching the web).Press "reset" button for 2

second(the LED turn green to red).

During this time make sensors to work (press any button on remote controller, make PIR and gap

sensors (move the two parts of door sensor) to work). They will be recognized and coded in the

system.

After 20s system is ready to work when the Status light turns green.

Test all sensors and repeat above procedure for any sensor, if is necessary.

Maximum number of wireless sensors that can be coded by system is 10 pcs.

But you can register countless wireless sensors by changing sensors' ID.

3. How to distinguish 4 LEDs on the main panel?

ALARM: It shows the working status of siren. If siren is triggered, this LED will be on.

MONITOR: When it is on, it means the system is in the status of listening-in.

STATUS: It shows the signal status. At the first beginning, it is red which shows the system is

searching for GSM network and then it will turn green when it finds GSM network. At this

moment, the GSM alarm system is ready to work.

POWER: This LED will be on when the system is switched on.

Ⅲ.Advanced Instructions

1. Resetting the system

NOTICE! After reset the system all coded information and messages will be lost.

System will be loaded with basic factory settings. The passwords will be back to

the original default-1234. You must code/register all wireless sensors again after reset.

Reset procedure:

System must be disarmed.

Press reset button and keep it pressed.

Ver 1.1

- 2 -