Cisco 6160 Notes sur l'installation et le remplacement - Page 12
Parcourez en ligne ou téléchargez le pdf Notes sur l'installation et le remplacement pour {nom_de_la_catégorie} Cisco 6160. Cisco 6160 18 pages. Without a pots splitter configuration
Également pour Cisco 6160 : Manuel de référence rapide (38 pages), Manuel d'installation du matériel (21 pages), Manuel de procédures d'installation (32 pages)
Imprimer la page
Removing and Installing the Cisco 6160 PEM
Power on the PEM by setting the circuit breaker to the ON (1) position, as necessary.
Step 7
Note
Verify that the INPUT OK LED is green.
Step 8
Note
Confirm that the Cisco IOS software recognizes the new PEM.
Step 9
Type the following command:
a.
DSLAM# show hardware chassis
Scroll through the data and locate the PEM information.
b.
The information displayed on the screen will be similar to the following output:
Slot 2 Power Module EEPROM:
Hardware Revision : 1.0
Part Number : 34-1259-01
Deviation Number : 0-0
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Chassis Serial Number : 000000PP830
Power Supply Type : DC
CLEI Code : ABCDEFGHIJ
Asset Identifier :
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 41 01 00 82 22 04 EB 01 80 00 00 00 00 03
0x10: 00 81 00 00 00 00 04 00 C2 8B 30 30 30 30 30 30
0x20: 50 50 38 33 30 0B 01 C6 8A 41 42 43 44 45 46 47
0x30: 48 49 4A CC 20 00 00 00 00 00 00 00 00 00 00 00
0x40: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0x50: 00 00 00 00 00 FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x80: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x90: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xA0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xB0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xC0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xD0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xE0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0xF0: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Note
Installing a PEM
12
The OUT FAIL LED might flash briefly.
If the INPUT OK LED is not green or if other issues arise, refer to the Cisco 6160 Hardware
Installation Guide for troubleshooting procedures.
If the information displays as "Unreadable" or "Unknown", the PEM was not installed properly
or a problem exists with the PEM. Install the PEM again by following the procedures in this
section. If the PEM is still not recognized by the system, refer to the Cisco 6160 Hardware
Installation Guide for troubleshooting procedures.
OL-2181-01