Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Upgrading the DRAM DIMM

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

Warning

touch the backplane with your hand or any metal tool, or you could shock yourself.

This section describes how to remove the existing DIMMs and replace them with the upgrade DIMMs.

The DRAM DIMM location is shown in

The Supervisor Engine 1A DRAM uses two DIMMs, one stacked on top of the other.

Note

Figure 3

BootROM

BootFlash

DRAM

Caution

Always use an ESD wrist strap when handling modules or coming into contact with internal components.

To install the DRAM upgrade, follow these steps:

Remove the DRAM DIMMs from the socket by pulling the locking spring clips on both sides of the

Step 1

DIMM holder outward, and tilt the DIMM free of the clips. (See

clips on the DIMM connector.

The Supervisor Engine 1A DRAM uses two DIMMs, one stacked on top of the other. Remove the upper

Note

DIMM first, and then remove the lower DIMM.

78-14357-02

DRAM Location

SWITCH LOAD

WS-X5530

100%

SUPERVISOR ENGINE I I I

CONSOLE

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Figure

Upgrading the DRAM DIMM

4.) Be careful not to break the