Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages)

To unseat the CFC daughter card from the Ethernet module, hold each tab at the rear of the CFC daughter

Step 6

card between your thumb and index finger, and gently press down on both tabs until the connectors are

unseated. (See

Do not apply too much pressure on the tabs because you might cause damage to the module.

Caution

Figure 3

Gently lift the CFC daughter card with both hands and remove the CFC daughter card from the module

Step 7

and immediately place the CFC daughter card in an antistatic bag.

Proceed to the

Step 8

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

OL-24918-02

Figure

3.)

Unseating the CFC Daughter Card Connectors

WS-X5530

"Installing a DFC4 Daughter Card" section on page

Removing a CFC or DFC3 Daughter Card

Heat sinks

23.